By default, the report is built:

When you load reports into the viewer;

When you switch from the report designer to the Preview tab;

When you click the Refresh button on the preview tab.
 

 

In this case, to rebuild the report, you need some action from the user. To rebuild a report automatically at a specified time interval, you should set the Refresh Time report property to:

One of the predefined values ​​from seconds to hours;

Enter the value in seconds manually. For example, if you want the report to be rebuilt every hour, enter 3600 (1 hour = 3600 seconds).

 

After the specified interval, the report will be automatically rebuilt.

 

 

Setting the report update time

 

Step 1: Run the report designer;

 

Step 2: Create or open a report;

 

Step 3: Left-click in the area between the page of the report template and the property panel;

 

Step 4: Select the Refresh Time property on the property panel, select a preset value or manually enter the value in seconds;

 

Step 5: Save the changes by clicking the Save button in the upper left corner of the report designer;

 

Step 6: Go to preview or open the report in the viewer by pressing the F5 button.

 

After the specified interval, the report will be rebuilt.