Programming language of a report

By default the report generator uses only one programming language for report code generation. It is used for automatic report code generation, for report events writing. If the current programming language of a report, by some reasons, is not fit your demand you can change it. For this choose «File | Report Setup», then choose in the «Language» new programming language. After pressing «Ok» the current programming language will be changed.

Important! The new report code will be generated for the whole report and all changes which have been done in the report code will be lost.

It is not convenient to change the programming language after report creation. Therefore you can can be change the programming language by default. For this you should use the Configurator utility. All programming languages in StimulReport.Net are located in the Languages folder. The language which, in the tree of services, is higher than the other one is the default programming language. For example, on the picture below the C# programming language is the default programming language. If you would like to have the VB.Net programming language as a default programming language you should drag the StiCSharpLanguage service on one position down.

Supported programming language

Programming languages supported by the report generator

Programming language by default

When report creating, the first programming language in the tree of services will be used as a programming language by default.

Buttons for control of position

If necessary to change the programming language by default you should use these buttons.